Error code
Samsung dryer: Jammed button
Samsung dryer — reported by blinking lights rather than by a code. The panel has decided one of its buttons is permanently pressed, so nothing else responds.
- From $95 diagnostic, credited to the repair
- 59 cities and neighborhoods covered
- OEM parts available on order
- In writing the price, before anything is opened
What we can confirm
Code Low, from the manufacturer's own documentation
This code has no number, because this equipment has no display to put one on. The appliance signals it instead — an alarm, a symbol or a pattern of lights — and what it means is recorded in the documentation that ships with it.
The code
Low
The panel has decided one of its buttons is permanently pressed, so nothing else responds.
or call (305) 506-1256
What it narrows down to
a button read as held down
Diagnostic
From $95, credited to the repair
On the same appliance
What else belongs to the dryers
On this make a code belongs to the appliance rather than to a product line. These are the other conditions this machine can display, and the models that can show this one — a display often has more than one thing to say, and the model number decides what any of it costs to put right.
Other codes this appliance can display
The supply reaching the dryer is not what it expects
The panel reads a button as permanently pressed
The door, its latch, or the switch that watches them
The temperature the dryer is measuring is not what it should be
The dryer is not reaching the heat it asked for
The boards inside the dryer have stopped agreeing
The supply frequency is not one the machine accepts
The load is taking longer to dry than the machine allows
The burner did not light when it was asked to
sensors and components, without a published procedure
the frequency error, in lights
the boards have stopped talking
The same digits mean different things on different equipment. Search the full code list
In more detail
About Samsung dryer: Jammed button
What the appliance is actually reporting
The panel has decided one of its buttons is permanently pressed, so nothing else responds.
Where this appears, and why not to clear it
On the cycle lights, on a machine with no digital display. Samsung publishes what each combination means, and on those models the combination is the entire diagnosis — it disappears the moment the power is cut. Write it down or photograph the panel before switching anything off. Samsung adds one caution of its own and it saves service calls: on some models the lights blink to show cycle status, so treat it as an error only if the machine is misbehaving as well.
Which machines this one applies to
Models with no digital display, which report by blinking their cycle lights. Samsung itself flags that several of its codes mean two different things depending on the model — dC, 3E and BE2 on washers, and 1E on dishwashers — so the model number is what settles which reading applies to your machine. It also publishes nothing at all for freezers, ice makers and range hoods, which is why those appliances have symptom pages here and no code pages.
What to do about it
- Power off at the wall.
- Touch and release every button, working each to its edges.
- Power back on; if the light returns at once, the panel is the repair.
Where this goes next
The job this usually becomes is appliance control board repair, and that page carries a starting figure and the reasons that move it. If it turns out to be nothing — and on this make a real share of these are modes, reminders and settings rather than problems — the visit ends there and you pay the diagnostic and nothing else, or call (305) 506-1256 and describe what the panel is doing before booking anything.
This article is based on:
- Official manufacturer documentation
- Internal repair procedures
- Technician repair history
- Company quality standards