Error code
Samsung dryer error code HC2
Samsung dryer error code HC2: A gas dryer that tumbles cold. Every spelling Samsung publishes for it, which machines can raise it, and what to do next.
- From $95 diagnostic, credited to the repair
- 59 cities and neighborhoods covered
- OEM parts available on order
- In writing the price, before anything is opened
What we can confirm
Code HC2, from the manufacturer's own documentation
A code is only meaningful together with the machine showing it — the same digits mean different things on different equipment.
The code
HC2
A gas dryer that tumbles cold. The sequence is an igniter that glows, a valve that opens and a flame sensor that confirms the flame, and this code means the sequence did not complete. Each of the three parts fails often enough to be worth telling apart before anything is ordered, and none of them is a job for an owner.
or call (305) 506-1256
What it narrows down to
The burner did not light when it was asked to
Diagnostic
From $95, credited to the repair
On the same appliance
What else belongs to the dryers
On this make a code belongs to the appliance rather than to a product line. These are the other conditions this machine can display, and the models that can show this one — a display often has more than one thing to say, and the model number decides what any of it costs to put right.
Other codes this appliance can display
The supply reaching the dryer is not what it expects
The panel reads a button as permanently pressed
The door, its latch, or the switch that watches them
The temperature the dryer is measuring is not what it should be
The dryer is not reaching the heat it asked for
The boards inside the dryer have stopped agreeing
The supply frequency is not one the machine accepts
The load is taking longer to dry than the machine allows
sensors and components, without a published procedure
the frequency error, in lights
a button read as held down
the boards have stopped talking
The same digits mean different things on different equipment. Search the full code list
In more detail
About Samsung dryer error code HC2
What HC2 means on this make
A gas dryer that tumbles cold. The sequence is an igniter that glows, a valve that opens and a flame sensor that confirms the flame, and this code means the sequence did not complete. Each of the three parts fails often enough to be worth telling apart before anything is ordered, and none of them is a job for an owner.
Where this appears, and why not to clear it
On the appliance's own display. Samsung reports errors two ways: machines with a digital display show a code, and the same machines without one blink their cycle lights instead. Both are published by the maker and both are on this site. Photograph what the panel shows before cutting the power — Samsung asks for this itself on its refrigerator and dishwasher pages, and it is the one thing that makes a first visit more useful. A code that has been reset is information a technician no longer has.
What to do about it
- Confirm the gas supply to the dryer is on and that other gas appliances in the house work.
- Power the dryer off for two to three minutes and try one more cycle.
- If it still will not light, stop there. A gas train is measured and tested rather than guessed at.
Where this goes next
The job this usually becomes is gas dryer igniter replacement, and that page carries a starting figure and the reasons that move it. If it turns out to be nothing — and on this make a real share of these are modes, reminders and settings rather than problems — the visit ends there and you pay the diagnostic and nothing else, or call (305) 506-1256 and describe what the panel is doing before booking anything.
This article is based on:
- Official manufacturer documentation
- Internal repair procedures
- Technician repair history
- Company quality standards