---
title: "Samsung washer error code 7E"
description: "Samsung washer error code 7E: SilverCare was a silver-ion dosing unit on some older Samsung washers."
url: "https://samsungmiami.support/error-codes/washer-silvercare/"
date_modified: "2026-09-04"
Appliance type: "Washers"
---


# Samsung washer error code 7E

### What 7E means on this make

SilverCare was a silver-ion dosing unit on some older Samsung washers. This code belongs to it and to nothing else, so it only ever appears on the machines that were built with it.

### Where this appears, and why not to clear it

On the appliance’s own display. Samsung reports errors two ways: machines with a digital display show a code, and the same machines without one blink their cycle lights instead. Both are published by the maker and both are on this site. Photograph what the panel shows before cutting the power — Samsung asks for this itself on its refrigerator and dishwasher pages, and it is the one thing that makes a first visit more useful. A code that has been reset is information a technician no longer has.

### What to do about it

- Switch the washer off for two to three minutes, power it back on and restart the cycle. Samsung publishes no procedure beyond this for these conditions, and neither will we.
- Note whether the code returns immediately or only during a particular part of the cycle. That single observation narrows it more than anything else you can do.
- If it returns, this is a measured diagnosis rather than a part swap, and it is what a diagnostic visit is for.

### Where this goes next

The job this usually becomes is [appliance control board repair](/services/appliance-control-board-repair/), and that page carries a starting figure and the reasons that move it. If it turns out to be nothing — and on this make a real share of these are modes, reminders and settings rather than problems — the visit ends there and you pay the diagnostic and nothing else, or call [(305) 506-1256](tel:+13055061256) and describe what the panel is doing before booking anything.

SilverCare error

What this one means

What 7E means on this make

SilverCare was a silver-ion dosing unit on some older Samsung washers. This code belongs to it and to nothing else, so it only ever appears on the machines that were built with it.

Where this appears, and why not to clear it

On the appliance’s own display. Samsung reports errors two ways: machines with a digital display show a code, and the same machines without one blink their cycle lights instead. Both are published by the maker and both are on this site. Photograph what the panel shows before cutting the power — Samsung asks for this itself on its refrigerator and dishwasher pages, and it is the one thing that makes a first visit more useful. A code that has been reset is information a technician no longer has.

What to do about it

Switch the washer off for two to three minutes, power it back on and restart the cycle. Samsung publishes no procedure beyond this for these conditions, and neither will we.

Note whether the code returns immediately or only during a particular part of the cycle. That single observation narrows it more than anything else you can do.

If it returns, this is a measured diagnosis rather than a part swap, and it is what a diagnostic visit is for.

Where this goes next

The job this usually becomes is appliance control board repair, and that page carries a starting figure and the reasons that move it. If it turns out to be nothing — and on this make a real share of these are modes, reminders and settings rather than problems — the visit ends there and you pay the diagnostic and nothing else, or call [(305) 506-1256](tel:+13055061256) and describe what the panel is doing before booking anything.

---

**[Read full article: Samsung washer error code 7E](https://samsungmiami.support/error-codes/washer-silvercare/)**